Efficient Fault Detection Algorithm in Fiber Optic Communication Systems

Main Article Content

Joni Welman Simatupang
Puspa Devi Pukhrambam

Abstract

Primary concern of optical communication system is the signal loss, which need to be traced precisely to enhance the efficiency of the system. Among numerous available techniques, optical time domain reflectometer (OTDR) is the most suitable one for characterizing and tracing the losses. It measures the fraction of a probe pulse that scatters back from the fiber optic cable. Due to the presence of small levels of backscattering in single-mode fiber at long wavelengths, very sensitive optical detector is necessary to achieve sufficient range performance. In the present research, a novel yet simple approach has been demonstrated to understand the range of optical fiber cable feasibility on fault detection and rectification technique. The actual place of fault is marked with the variation in the measured values of OTDR. Thus, it becomes a difficult task to trace and locate the actual place of fault detection, which leads to an inefficient rectification method. The observed values of OTDR shows a gradual decrease of accuracy in locating the actual place of fault. To resolve these issues, here we try to develop an algorithm which is able to easily and efficiently trace the exact location of fault on earth.

Article Details

How to Cite
Simatupang, J., & Pukhrambam, P. (2023). Efficient Fault Detection Algorithm in Fiber Optic Communication Systems. Jurnal Teknologi Informasi Indonesia (JTII), 7(2), 66-74. https://doi.org/10.30869/jtii.v7i2.913
Section
Articles

References

[1] V. Kumar and D. Rajouria, “Fault Detection Technique by using OTDR: Limitations and drawbacks on practical approach of measurement”. International Journal of Emerging Technology and Advanced Engineering (IJETAE) ISSN, 2012, 2(6), pp.2250-2459.
[2] P.D. Murugesh, R. Damini, P. Amitha, M. Shwetha, “IoT Based Underground Optical Fiber Cable Fault Detection System.” International Journal of Advanced Research in Basic Engineering Sciences and Technology, 2019, 5(2).
[3] J. Ilouno, M. Awoji, B.J. Kwaha, and N.M.D. Chagok, “Comparative Analysis on Fault Detection Techniques in Fiber Optics Communication Links.” International Journal of Innovative Scientific & Engineering Technologies Research 2018, 6(2), pp.1-10
[4] A.V.N. Vamsi and A.B. Rao, “Fault Detection in Fiber Optic Communication Cable by Coherent Anti-Stokes Raman Scattering using Superconducting Nanowire Single-Photon Detector”. Indian Journal of Science and Technology, 9(1), 2016, pp.1-6.
[5] G. Baskaran and R. Seethalakshmi, “Intelligent Fault Detecting System in an Optical Fiber.” J. Theor. Appl. Inf. Technol., 2012, 39(2), pp.178-187.
[6] K. Swain, J. Sahoo, M.V.S.V. Prasad, and G. Palai, “Fault Detection System in an Optical Fiber Using Arduino”. International Journal of Applied Engineering Research, 2015, 10(44), pp.31745-31749.
[7] Technical Review by NTT, “Fault Cases and Countermeasures for Optical Fiber Cables in Optical Network Facilities” 2011.
[8] B.C. Choudhary, Optical Time Domain Reflectometry (OTDR), Power Point Presentation, 32 slides, NITTTR.
[9] Agilent Technologies, OTDR Guide, April 2001.
[10] J. W. Simatupang and S.-L. Lee, “Transfer matrix analysis of backscattering and reflection effects on WDM-PON systems,” Opt. Express 21(23), 27565–27577 (2013).
[11] Simatupang, J.W.; Pukhrambam, P.D.; Huang, Y.R. “Performance analysis of cross-seeding WDM-PON system using transfer matrix method.” Opt. Fiber Technol. 2016, 32, 50–57.
[12] Simatupang, J.W.; Lee, S.-L. “Theoretical and g simulation analysis on potential impairments in bidirectional WDM-PONs.” In Proceedings of the IEEE 3rd International Conference on Photonics, Penang, Malaysia, 1–3 October 2012; pp. 61–65.
[13] Simatupang, J.W.; Lin, S.-C. “A study on Rayleigh backscattering noise in single fiber transmission PON.” Int. J. Innov. Res. Technol. Sci. 2016, 4, 11–15
[14] J. Simatupang, “Theoretical Analysis of Backreflections in Bidirectional Wavelength Division MultiplexingPassive Optical Networks,” Bulletin of Electrical Engineering and Informatics (BEEI), Vol. 2, no. 1, pp. 45–52, Mar. 2013.
[15] T.A. Ali and J. J. H. Ameen, “Study of Fault Detection Techniques for Optical Fibers,” ZANCO Journal of Pure and Applied Sciences, Vol.31(s3), pp.143-149, DOI: http://dx.doi.org/10.21271/ZJPAS.31.s3.20.